Stradalli Cycle Full Carbon Fiber Classic Drop Ergo Road Bike Bicycle Stem Handlebar Drop Bar W-17 White 40 42 44 cm

Road Bike Full Carbon Fiber Handlebars W-17 400mm

More Views

  • Road Bike Full Carbon Fiber Handlebars W-17 400mm
  • Road Bike Full Carbon Fiber Handlebars W-17
  • Road Bike Full Carbon Fiber Handlebars W-17
  • Road Bike Full Carbon Fiber Handlebars W-17
  • Road Bike Full Carbon Fiber Handlebars W-17
  • Road Bike Full Carbon Fiber Handlebars W-17
  • Road Bike Full Carbon Fiber Handlebars W-17

* Required Fields

$94.99

Details

Stradalli Cycle Full Carbon Fiber Classic Drop Ergo Road Bike Bicycle Stem Handlebar Drop Bar W-17 White 40 42 44 cm

100% 3K Carbon Fiber.

Classic Road Drop 

Handlebars for 31.8mm stem
240 g
Drop/Reach 145mm/90mm

Internal cable routing

Reinforced and textured clamping area for secure mounting.

Textured handles for sturdy tape application.

Our quality is world class, competition rated.

 

Stradalli cycle carbon fiber Handlebar Installation Instructions

A. Measure the stem clamp diameter. The Stradalli cycle carbon fiber handlebar is only compatible with stems that have a 31.8mm clamp diameter.     

Remove all sharp edges and burrs on the stem clamp area. Failure to do so may result damage to the handlebar that can cause failure, loss of control of bicycle, injury or death.   

B. Apply Carbon fiber Installation Compound on stem and faceplate surfaces that contact the handlebar. 

C. Place the handlebar into the Stem Body and install the Face Plate, lightly tightening the Face Plate Bolts but do not tighten. 

Center and adjust the position of the handlebar. Stradalli cycle carbon fiber road handlebars are designed to be set up with the ends of the bars approximately horizontal (0° - 6°). This will give the best position for riding in the drops and short reach to the brake lever.   

D. Tighten stem face plate bolts according to stem manufacturer’s instructions.   

Tighten faceplate bolts only a ¼ turn at a time, alternating between the bolts in an “ X ” pattern. Failure to do so will result in damage to the handlebar that is not covered under warranty. 

Tighten the bolts to the Minimum amount of torque necessary to secure the handlebar. 

Do NOT exceed 60kgf.cm of torque. 60 kgf.cm / 6 Nm / 52 in.lbs, is the maximum torque for most M5 stem bolts. 

Failure to comply with these instructions may result in damage to the bar causing loss of control of bicycle, injury, or death.

Product ID: 1246